Section D
Section D - Code Control ModuleIMPORTANT: Although a code is shown in the upper right hand corner of screen, the control unit still must be coded.
- Connect VAS 5051 / 6 diagnostic cable harness to data link connector located under dash on left side
- Turn Ignition "ON"
- From VAS 5051 Start-Up screen press "Vehicle Self Diagnosis" button
- Select "01 - Engine Electronics"
- Select "02 - Interrogate fault memory"
- Press (<) button
- Select "05 - Erase fault memory" if required
- Press (<) button
- Select "11 - Login-Procedure"
- Press buttons -1-, -2-, -8- and -3- to input Login code 1283
- Press -Q- button to confirm
- Press (<) button when "Function Performed Successfully" comes on in upper left corner of screen
- Select "07 - Code Control Unit"
IMPORTANT: Although a code is shown in the upper right hand corner of screen, the control unit still must be coded.
- Enter relevant code number for vehicle noting model year and options
- Press -Q- button to confirm input
NOTE:
- Message "Function is unknown or cannot be carried out" is displayed if an unauthorized code number has been entered
- ECM identification and coding are displayed in upper right corner of screen
- Press (<) button when "Coding of vehicle completed" comes on screen in upper left corner
- Proceed to Section E