Turn Signal Lamp: Service and Repair

Front turn signals are part of the headlamp assembly.
- Removing headlamp assembly: Service and Repair
- Removing front turn signal bulb: Service and Repair
Rear turn signals are part of the tail lamp assembly. Tail Lamp


Side Mounted Turn Signals

Removing

NOTE: Extreme caution must be used when removing the side mounted turn signal since it can only be removed in one direction and it is not possible to recognize on which side of the turn signal the spring clip or the mounting sits. When using force to remove the light on the spring clip side, there is a risk of damaging the turn signal or the vehicle paintwork surface.





- Carefully press turn signal using suitable tool on mounting side -1- in direction of arrow against force of spring clip -2- on opposite side and remove (protect paint surface using adhesive tape if necessary).
- Pull rubber holder and push-fit bulb from bulb housing.
- Pull push-fit bulb (12 V/5 W) from holder (do not turn).

Installing
- Attach rubber holder and push-fit bulb to bulb housing.
- Insert turn signal into fender.
- Always check turn signal function after installing new bulb.