Sealing Flange and Flywheel/Drive Plate Assembly Overview

Sealing flange and flywheel/drive plate assembly overview

Note: Servicing clutch, refer to Transmision and Drivetrain - Clutch, M/T [1][2]Clutch






1- 90 Nm plus an additional 1/4 turn (90°)
Replace
Counterhold with 3415 to loosen and tighten
Threads and shoulder must be free of oil and grease

2- Crankshaft toothed belt sprocket
3- 15 Nm

4- Seal
Replacing. refer to Crankshaft Seal, Ribbed Belt Side, Replacing Service and Repair

5- Sealing flange
Must be located on dowel sleeves
Clean sealing surface before installing
Insert with silicone sealant D 176 404 A2
Removing and installing, refer to Crankshaft Seal, Ribbed Belt Side, Replacing Service and Repair
To remove and install remove oil pan

6- Cylinder block
Removing and installing crankshaft, refer to Crankshaft
Disassembling and assembling pistons and connecting rods, refer to Pistons and Connecting Rods, Assembly Overview

7- 60 Nm plus an additional 1/4 turn (90°)
Replace

8- Flywheel/drive-plate
To remove and install flywheel counterhold with 3067
Removing and installing drive plate, refer to Drive Plate, Removing and Installing Flex Plate

9- Intermediate plate
Must be located on dowel sleeves
Do not damage/bend when assembling

10- Sealing flange with oil seal
Only replace as complete unit
To remove and install, remove oil pan.
Before installing, remove oil residue from crankshaft journal using a clean cloth
Do not additionally oil or grease the oil seal sealing lip
Use protective sleeve supplied when installing
Remove protective sleeve first after sealing flange has been slid onto crankshaft journal