With Manufacturer Scan Tool

Diagnostic Trouble Code (DTC) memory, checking (function 02)


NOTE:
- DTCs stored in memory along with corresponding malfunction descriptions can only be displayed by initiating the On Board Diagnostic program and checking DTC memory (function 02)
- Displayed DTC information is not constantly updated. Information can only be displayed information by initiating the On Board Diagnostic program and checking DTC memory (function 02) or with function 05 "Erase DTC memory".


- Switch on printer with Print button (indicator lamp in keylights up).

Indicated on display (select function):


Rapid data transfer HELP
Select function XX.


- Press buttons -0- and -2- to select function 02 "Check Diagnostic Trouble Code (DTC) memory".

Indicated on display:


Rapid data transfer Q
02 - Check DTC memory


- Press -Q- button to confirm input.

The number of stored malfunctions appear in the display.


X DTC recognized! ->


The number of stored DTCs or "No DTCs recognized" appears in the display and are printed out one after another.

- When the last DTC has been displayed and printed out, rectify malfunctions as described in DTC table. Refer to "About Trouble Codes", under "Instrument Panel, Gauges and Warning Indicators/Trouble Code Diagnostic Charts (Trouble Code Tables)", CAN Bus

If "No DTC recognized" is displayed, the program will return to the initial position after pressing -> button.


No fault recognized! ->


Indicated on display (select function):


Rapid data transfer HELP
Select function XX


If display not indicated as shown:

See Scan tool operating instructions

- End output (function 06).
- Switch off ignition and disconnect Data Link Connector (DLC).