No DTC Recognized

Output on printer
VAG 1551
No DTC recognized! If "No DTC recognized" appears after performing repairs, the On Board Diagnostic (OBD) is completed.
If the automatic transmission does not operate properly after checking the DTC memory and correcting any malfunctions:
See Measured value block, reading.

NOTE: Do not replace the Transmission Control Module -J217-, or return the system to basic setting until the possible cause of any malfunction has been determined and the following types of malfunction have been corrected:
- Mechanical malfunctions
- Hydraulic malfunctions
- All affected electrical/electronic components and wrong connections