Clutch Release Mechanism, Servicing

5 Speed Manual 02J

Clutch Release Mechanism, Servicing






1 Transmission
2 Ball stud
- 25 Nm (18 ft. lbs.)
- Lubricate with MoS2 grease
3 Input shaft oil seal
4 Guide sleeve
- With vulcanized O-ring
- If damaged replace guide sleeve and O-ring together
- Lubricate guide sleeve in area of release bearing with MoS2 grease
5 Retaining spring - Secure to clutch release lever
6 Bolt
- 20 Nm (15 ft. lbs.)
7 Clutch release lever
8 Release bearing
- Do not wash bearing out, only wipe
- Replace noisy bearings
- Lubricate surfaces which contact release lever with MoS2 grease
9 Bolt
- 20 Nm (15 ft. lbs.)
10 Slave cylinder
11 Plunger
- Grease end of plunger with MoS2 grease
12 Assembly bolt
- Secures the clutch release lever when installing transmission
- Remove after transmission has been installed

Note:

- If the assembly bolt (Item 12) is not available, an M8 x 35 bolt can be used.