With Generic Scan Tool
Check Oxygen Sensor And Oxygen Sensor Regulation Behind Catalytic Converter
NOTE:
- Vehicle must be raised before connector for oxygen sensor is accessible.
- When servicing terminals 3 and 4 in harness connector of Heated Oxygen Sensor (HO2S), use only gold-plated terminals.
Recommended special tools and equipment
- VAG 1526 multimeter or VAG 1715 multimeter
- VAG 1594 connector test kit
- Wiring diagram
Test requirements
- The respective fuses of Heated Oxygen Sensor (HO2S) -G130- must be OK.
- Battery voltage must be at least 11.5 volts.
- All electrical consumers such as, for example, lights and rear window defroster must be switched off.
- Parking brake must be engaged or else daylight driving lights will be switched on.
- For vehicles with automatic transmission, selector lever must be in position -P- or -N-.
- If vehicle is equipped with an A/C system, it must be switched off.
- Ground (GND) connections between engine and chassis must be OK.
- Exhaust system must be properly sealed between catalytic converter and cylinder head.
- Coolant temperature must be at least 80°C.
- Oxygen sensor heater for oxygen sensor behind catalytic converter must be OK.
Function test
- Select the following output of oxygen sensor signals and check whether the specified values are being reached, Diagnostic mode 5: Check output of oxygen sensor signals.
If specified values are obtained:
- End diagnosis and switch ignition off.
If specified values are not obtained:
- End diagnosis and let engine continue to run at idle.
- Check primary voltage.
Checking primary voltage
- Unscrew protective cover (arrows) and disconnect 4-pin harness connector (brown) -1- to Oxygen Sensor (O2S) behind Three Way Catalytic Converter (TWC) -G130-.
- Connect multimeter for voltage measurement to terminals 3 + 4 of connector to Engine Control Module (ECM) and measure primary voltage. Specified value: 0.400 to 0.500 Volts
- Switch ignition off.
If specified value is not obtained:
- Test oxygen sensor wires.
If specified value is obtained:
- Replace Oxygen Sensor (O2S) 2 Bank 1 Behind Three Way Catalytic Converter (TWC) -G130-:
- Vehicles with engine code AEG, item 10,
- Vehicles with engine code AVH, AZG, BDC, item 11.
- Erase DTC memory of Engine Control Module (ECM)
- Generate readiness code.
Checking oxygen sensor wires
- Connect test box to control module wiring harness, connect test box for wiring test.
Vehicles with engine code AEG
- Check wires between test box and 4-pin connector (to control module) for open circuit according to wiring diagram.
- Terminal 3 + socket 51
- Terminal 4 + socket 52
- Wire resistance: max. 1.5 Ohms
Vehicles with engine code AVH, AZG, BDC
- Check wires between test box and 4-pin connector (to control module) for open circuit according to wiring diagram.
- Terminal 3 + socket 68
- Terminal 4 + socket 69
- Wire resistance: max. 1.5 Ohms
Continuation for all vehicles
- Also check wires for short circuit to B+ and Ground (GND). Specified value: Infinite Ohms
If no malfunctions are found in wires:
- Replace Motronic Engine Control Module (ECM) -J220-.