Door Handle & Door Lock, Assembly Overview

Door Handle & Door Lock, Assembly Overview






1. Door lock
Door lock can only be removed with assembly carrier in conjunction with the subframe
Removing and installing refer to Front Door Lock, Removing & Installing Front Door Lock, Removing & Installing
Cover -4- was introduced as a running change in production for the lock. It is clipped onto the lock and must be installed again or retrofitted when replacing the door lock.

2. Cable
Lock release

3. Angle bracket
Bolted and riveted to door lock
Does not belong to door lock delivery casing

4. Cover
Does not belong to door lock delivery casing
Must be reinstalled or retrofitted when replacing door lock

5. Mounting bracket
Removing
Door handle, lock cylinder housing and subframe have been removed
Remove Phillips head screw -6-, slide mounting bracket slightly to rear and remove from door.

6. Phillips head screw

7. Door handle with backing plate
Removing & installing refer to Body and Frame - Doors, Hood and Trunk - Door - Door Handle - Service and Repair - Procedures - Door Handle, Removing & Installing Service and Repair

8. Key with radio-frequency remote control (non-foldable)
9. Key with radio-frequency remote control (foldable)
10. Concealment cap

11. Lock cylinder housing
Removing refer to Door Lock Cylinder - Service and Repair - Procedures Service and Repair
Lock cylinder is not available as an individual replacement part

12. Base plate

13. Socket head bolt
T 10011 Socket wrench
T 10072 Socket wrench
By loosening this bolt, locking mechanism for lock cylinder housing -11- is disengaged and may be removed from mounting bracket -5-
Phillips head screw -6- must not be threaded in without lock cylinder housing installed as lock mechanism ring may fall into the door.