Turn Signals: Testing and Inspection

Checking turn signal and emergency flasher system

Required for troubleshooting:
- Multimeter Fluke 83
- Connector Test Kit VW 1594
- Valid wiring diagram

Note: Before starting troubleshooting, battery negative terminal must be securely tighted.

Test Conditions:
- S2 - Fuse 2 (10A) in fuse panel OK
- S239 - Fuse 39 (15A) in fuse panel OK
- All turn signal bulbs OK

CAUTION: DO NOT damage, enlarge or bend connector terminals or cavities by forcing probes into them when performing electrical checks. Always use connector test kit VW1594 to make the necessary electrical connections.

Preparation:
- Switch OFF ignition and all electrical consumers.
- Remove Emergency Flasher Switch (E3)
- Remove turn signal switch trim

Note: If malfunction has not been eliminated after all test steps, replace Emergency Flasher Switch (E3).

After repairing malfunction, please perform functional test of turn signal and emergency flasher system.