I-ATF Pump to Support Tube, Removing and Installing

I-ATF Pump To Support Tube, Removing And Installing
Refer to Overview.
Transmission, disassembling.
Assembling. Disassembling and Assembling





1. Bolt
^ Qty. 7
^ Tighten to 8 Nm (71 inch lbs.) + additional 90° turn
^ Additional 90° turn may be done in several stages
2. ATF pump with -B2- piston
^ Spare part must agree with transmission code letters
^ Disassembling and assembling.
3. O-ring
^ Always replace
^ Place on ATF pump
4. Gasket
^ Always replace
5. Spring cap, Qty. 6
^ Install 3 spring caps after installing first outer plate
^ Install 3 spring caps before installing last outer plate
6. Spring
^ Qty. 3
7. Retaining ring
8. Shim
9. Outer plate -B2-
^ 3 mm thick
10. inner plate -B2-
^ Quantity refer to Application and ID.
^ Before installation place new inner plates in ATF for 15 minutes
11. Outer plate -B2-
^ Always install 2 mm thick outer plates
^ Quantity.
12. Outer plate -B2-
^ Install 3 mm thick outer plate to supporting tube
13. Supporting tube -B2-
^ For -B2- plate package
^ Spare part must comply with transmission code letters
^ Insert with groove engaging in wedge of free wheel
14. Transmission housing with clutches installed