Sunroof With Glass Panel, Assembly Overview

Sunroof With Glass Panel, Assembly Overview







1 - Glass panel for sunroof (single pane safety glass)
- Removing glass panel for sunroof
- Installing glass panel for sunroof
- Adjusting glass panel for sunroof

2 - Panel seal
- Adjusting panel seal
- Seal join at center in rear area
- Panel seal, replacing

3 - Sliding headliner
- Removing and installing sliding headliner

4 - Countersunk screws (microencapsulated)
- Always use new countersunk screws
- 3.5 Nm

5 - Slider
6 - Upper trim
- Up to calender week 35 2002 (CW 35/02)

7 - Lower trim
- Up to calender week 35 2002 (CW 35/02)

8 - Water channel
- Removed together with slotted guide rail

9 - Guide locking hook
10 - End piece
- Use Butyl adhesive sealing cord AKL 450 005 05 for sealing

11 - Installation unit
- if necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise functions cannot be guaranteed.

12 - Bolt
- 3.5 Nm

13 - Hex wrench for emergency operation
- Clipped in on drive motor cover

14 - Drive motor
- Adjusting drive motor (zero position)

15 - Spring
16 - Wind deflector
17 - Torx screw
- Torx T25
- 4.5 Nm

18 - Rear guide
- Removed together with slotted guide rail

19 - slotted guide rail
20 - Gap bracket
- Removed together with slotted guide rail

21 - Trim piece
- From calender week 36 2002 (CW 36/02) on

NOTE: Trim piece and trim must not be replaced against each other. Clearance for mechanical components is otherwise not guaranteed.