Solenoid Valves In Valve Body, Checking

Solenoid Valves In Valve Body, Checking

Recommended special tools and equipment
- V.A.G 1526 multimeter or V.A.G 1715 multimeter
- V.A.G 1594 connector test kit
- Wiring diagram

Requirements
- Respective fuses must be OK.
- Selector lever must be in -P- position.
- All electrical consumers such as, lights and rear window defroster must be switched off.
- Parking brake must be engaged.
- Ground (GND) connections to transmission must be OK.
- Ignition switched off.

Work sequence
- Disconnect 12-pin harness connector at transmission.
Observe safety precautions.

- Check harness connector for contact corrosion and ingress of water.

If harness connector is not OK.
- Repair malfunction.
- Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes.

If harness connector is OK.
- Check resistance of solenoid valves.

Checking resistance of solenoid valves
- Re-connect 12-pin connector.
- Connect test box to control module wiring harness, connect test box for wiring test.
- Measure resistance of solenoid valves at test box between sockets:







NOTE: Resistance value is valid at approx. 20 degrees C. At higher temperatures, resistance value increases.

If one of the specified values is not obtained.
- Check wires to Transmission Control Module (TCM) according to wiring diagram.

Checking wires to Transmission Control Module (TCM)
- Checking wires to Transmission Control Module (TCM)







- Check wires between test box and 12-pin connector to Transmission Control Module (TCM) for open circuit according to wiring diagram.

Wire resistance: max. 1.5 Ohms







- Check wires for short circuit to each other.

Specified value: Infinite Ohms

If no malfunctions are found in wires.
- Replace circuit board or valve body:
- Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes.