Shift Lever and Shift Lever Housing, Servicing

Shift lever and shift lever housing, servicing
Note: Lubricate all mountings and sliding surfaces with Polyurea grease Part No. G 000 450 02.

1 - Circlip
^ Removing and installing, Refer to Fig. 1
2 - Bushing
3 - Spring
4 - Bushing
5 - Torx screw, 5 Nm
6 - Cover plate
7 - Damper
8 - Bearing shell
9 - Gear shift guide
10 - Damping washer
11 - Gasket
^ Between shift housing and floor
^ Self-adhesive
^ Bond to shift lever housing
12 - Transmission shift lever
13 - Damper
14 - Shift housing
15 - Bushing
16 - Bolt, 25 Nm
17 - Fulcrum pin
18 - Guide bushing
19 - Spring
^ Installing, Refer to Fig. 2
20 - Gate selector bracket
21 - Torx screw, 5 Nm
22 - Base plate
^ Open tabs to remove
^ Replace
23 - Lock washer
24 - Gate selector cable
25 - Gear selector cable
26 - Hex nut, 25 Nm
27 - Bushing
^ Only installs in one position
28 - Lock washer





Fig. 1 Removing and installing circlip
^ Pull shift lever in arrow direction -A- and at same time push down spacer bushing onto stop with a screwdriver in arrow direction -B-.

Note: Do not tilt spacer bushing when pushing down. Carefully release pressure at groove in gear lever for circlip.
Carefully release pressure at groove in gear lever for circlip.





Fig. 2 Installing spring
^ Insert spring so that spring extension -A- lies above pin (arrow).
^ Pull spring extension -B- down so that it reaches below pin (arrow).