Code Control Module (Function 07)
Code Control Module (Function 07)
NOTE:
- The control module is supplied pre-coded according to the vehicle equipment.
- Coding is performed with the VAG 1551 Scan Tool (ST).
- Connect VAG 1551 scan tool. Refer to "Selectable Functions When Using VAG 1551", under "Restraint Systems", Scan Tool Connecting and Initial Checks
- Initiate On Board Diagnostic (OBD). On Board Diagnostic (OBD), Initiating Program
Indicated on display
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -7- to select "Code Control Module" function 07.
Indicated on display
Rapid data transfer Q
07 - Code Control Module
- Press -Q- button to confirm input.
Indicated on display
Code control module Q
Enter code number XXXXX (0-32000)
- Enter code 00256.
- Press -Q- button to confirm input.
The control module identification number will be displayed with the corresponding letter index, the code number and the dealership number.
1C0 962 258 P0G Cent. Lock. 0001 ->
Coding XXXXX WSC XXXXX
If the contents of the display are as shown then the coding is successful.
If the code number entered is not accepted by the control module, the previous coding will appear in the display.
Indicated on display
1C0 962 258 P0G Cent. Lock. 0001 ->
Coding XXXXX WSC XXXXX
In this case the control module has not been programmed with the relevant data for the vehicle. A test must be completed to determine if the correct control module for the vehicle has been installed (compare Part No. and letter index), or whether an incorrect code number has been entered.
- Repeat coding.
The following code numbers (and others) will be accepted by the control module; however they are for other vehicles, other countries and/or other equipment levels.
If the control module cannot be coded (correct control module, correct code number), the control module is faulty.
If an incorrect code was entered and accepted by the control module (e.g. 04096), the display will indicate that communication could not be established with, for example, the rear door locking units.
Indicated on display
Door control module. BF0022 ->
No communication
- Repeat coding.
End Output (function 06)
- Press -> button.
Indicated on display
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -6- to select "End Output" function 06.
- Press -Q- button to confirm input.
Indicated on display
Rapid data transfer Q
06 - End Output
- Switch ignition off.
- Disconnect scan tool from Data Link Connector (DLC).