Transmission Housing Cover and 5th Gear

5 Speed Manual 02J

Transmission Housing Cover And 5th Gear, Removing And Installing





1 Bolt
- 10 Nm (7 ft. lbs.)
- For transmission housing cover
2 Transmission housing cover

Note:
If the transmission cover is in place with the transmission installed, check oil level as follows:
- Fill with oil up to lower edge of filler hole and install filler plug.
- Start engine, engage gear and allow transmission to turn for approx. 2 minutes.
- Switch off engine and top up transmission oil to lower edge of filler hole again.

3 Gasket
4 Torx socket-head bolt
- 80 Nm (59 ft. lbs.)
- M10
- Bolt head holds dished washer in position
5 Dished washer
6 Socket-head bolt
- 25 Nm (18 ft. lbs.)
- For pivot pin to transmission housing
7 Pivot pin
8 5thgear selector fork
9 5th gear operating sleeve
10 Synchronizer hub with 5th gear and synchronizer ring
11 Needle roller bearing
12 5th gear