Input Shaft, Output (Pinion Shafts) Differential, Selector Rods

Input shaft, output shafts (pinion shafts), differential and selector rods, disassembling and assembling





1- Output shaft for 1st-4th gear
^ Installation position, Refer to Fig. 1
2- Selector rod with selector fork 1st and 2nd gear
^ Installation position, Refer to Fig. 2
3- Selector rod with selector fork for 3rd and 4th gear
^ Installation position, Refer to Fig. 2
4- Output shaft for 5th, 6th and reverse gear
^ Installation position, Refer to Fig. 1
5- Selector rod with selector fork for 5th and 6th gear
^ Installation position
6- Reverse gear selector fork
^ Installation position
7- Input shaft
8- Reverse shaft
9- Thrust washer
10- Bleeder
^ Bolt to slave cylinder pipe
11- Clip
12- Clutch housing
13- Input shaft oil seal
14- O-ring
^ Replace
15- Slave cylinder with release bearing
16- Hex bolt, 12 Nm
^ Qty. 3
17- Cone head bolt, 25 Nm
18- Flange shaft with spring
19- O-ring
^ Always replace
20- Speedometer sender
21- Hex bolt, 12 Nm
22- Differential





Fig. 1 Installation position of output shafts (pinion shafts) in transmission
1- Output shaft for 5th/6th and reverse gear
2- Input shaft
3- Output shaft for 1st-4th gear
4- Differential





Fig. 2 Installation position of complete selector mechanism in transmission
1- 3rd and 4th gear selector fork
2- 1st and 2nd gear selector fork
3- Reverse gear selector fork
4- 5th and 6th gear selector fork
5- Selector shaft
The lower selector shaft mounting -arrow- is bolted to the cover plate.