With Manufacturer's Scan Tool

On Board Diagnostic (OBD), Characteristics

The Engine Control Module (Motronic Engine Control Module (ECM) -J220-) is equipped with DTC memory.

When malfunctions occur in monitored sensors or components, Diagnostic Trouble Codes (DTCs) are stored in DTC memory with a description of the malfunction type.

The Engine Control Module (ECM) selects from 216 possible Diagnostic Trouble Codes (DTCs) according to its evaluation of the malfunction information DTC table or and stores this code until DTC memory contents are erased. Testing and Inspection

Malfunctions that occur only intermittently (sporadically) are printed out with the added text "sporadically occurring malfunction". These malfunctions are indicated on the display with the added text "/SP". Sporadic malfunctions are frequently caused by loose contacts or brief open circuits. A sporadic malfunction will be erased if it no longer occurs after 40 warm-up cycles (engine started with coolant temperature below 50°C - switched off above 72°C).

Stored DTCs can be identified using the V.A.G1551 or VAG1552 Scan Tools or the new VAS5051 tester.

If the connector is disconnected from the ECM or the battery is disconnected, all adaptation values in the control module are erased. DTC memory content will remain intact however. If the engine is started after this, a rough, uneven idle can result. In this case, engine must be allowed to run at idle for a few minutes or a longer road test must be performed until the adaptation procedure has been completed. Procedure to follow after open circuit in voltage supply. Testing and Inspection

DTC memory must be erased after malfunctions are repaired and the readiness code must be re-generated. Monitors, Trips, Drive Cycles and Readiness Codes

NOTE: General information regarding On Board Diagnostic (OBD) can be found in the operating instructions for the V.A.G1551, VAG 1552 or the new VAS5051 tester.