Installation Notes

Installation Notes

Surfaces of components to be primed must be free of dirt.
- Remove adhesive residue using Adhesive removal solution D 002 000 10.
- Saturate a cloth with Silicone remover LSE 020 100 A3.
- Always wipe application area for adhesive bead twice using saturated cloth and allow to air dry.
- Now apply primer uniformly in one stroke using Applicator D 009 500 25.
- Air dry time approx. 10 minutes

- Adhesive material must be applied to primed surfaces of component.

CAUTION: Components must be installed within 10 minutes, otherwise bonding properties of adhesive will be impaired.

- Keep gap dimensions as narrow as possible, up to approx. 1 mm.
- Secure components using adhesive tape during curing time.