Glass Panel For Sunroof, Installing

Glass Panel For Sunroof, Installing

Panel must be installed in zero position (panel closed).

Zero position:

Vehicles up to calender week 31 1998 (CW 31/98)







Square holes in tilt levers must align with grooves in guide rails - arrow -.

Vehicles from calender week 32 1998 (CW 32/98) on







Guide rail pin must align with marking (pin) on guide rail - arrow -.

If this is not case, adjust parallel movement.
- Insert sunroof panel from above and screw in securing bolts (guide rail/panel).







- Slightly tighten securing bolts - 1 - and - 2 - (Torx T25).
- Adjusting glass panel for sunroof (height adjustment).

NOTE: Tighten securing bolts after panel height adjustment (4.5 Nm).

Vehicles up to calender week 35 2002 (CW 35/02)
- Install lower trim and upper trim after panel height adjustment.

Vehicles from calender week 36 2002 (CW 36/02) on
In vehicles from calender week 36 2002 (CW 36/02) on, a trim piece is installed in place of a lower trim and an upper trim.

NOTE:
- Trim piece and trim must not be replaced against each other. Clearance for mechanical components is otherwise not guaranteed.
- Install trim piece after panel height adjustment.