Glass Panel For Sunroof, Adjusting (Height Adjustment)

Glass Panel For Sunroof, Adjusting (height Adjustment)

Zero position of sunroof OK.
- Tilt sunroof open.
- Slide sun protection toward rear.







- Unclip lower trim - 2 - in front area to vehicle center and unhook at rear.
- Unclip upper trim - 1 - at front and in center and disengage at rear.
- Loosen securing bolts - 3 - (25-Pin Connector T25 ; 4.5 Nm).
- Drive glass panel into "closed" position.
- Perform glass panel height adjustment at front and rear on both sides as follows:







Panel adjustment at front:
- a - = 0 to 1 mm lower than roof
- arrow - = direction of travel







Panel adjustment at rear:
- b - = 0 to 1 mm higher than roof
- arrow - = direction of travel
- Tighten glass panel bolts (4.5 Nm).

Always adjust left and right-hand glass panel sides symmetrically.

- Tilt sunroof open.







- Hook upper trim - 1 - at rear and clip on in center and at front.
- Hook in lower trim - 2 - at rear and clip in at front.