DTC's Displayed By (ABS) Mark 60 Warning Lamps

DTCs displayed by (ABS) Mark 60 warning lamps -K32-, -K47-, -K118-, and -K155








Warning lamps

Brake pad wear indicator light -K32





^ If the brake pad wear indicator light -K32- -1- does not go out after ignition is switched on and test sequence is completed, or it lights up while driving, then the malfunction may be:
-a- The brake pads can be worn out
Check the front and rear brake pads.
-b- There is a malfunction in the activation of the brake pad wear indicator light -K32-.

ABS warning light -K47





^ If the ABS warning light -K47- -2- does not go out after ignition is switched off and test sequence is completed, then the malfunction may be:
-a- Voltage supply is below 10 Volt.
-b- There is a malfunction in the ABS.
The anti-lock brake system remains switched off with an ABS malfunction -b-, but the brake system remains fully operational.
-c- Since the last time the vehicle was started there was a temporary speed sensor malfunction.
In the case of a sensor malfunction -c-, the ABS warning light -K47- will extinguish after restarting the engine and attaining a speed of above 20 km/h (approximately 13 mph).
-d- The connection of instrument cluster to ABS control module (w/EDL) -J104- is interrupted.
-e- Instrument cluster is faulty.

Warning lamps -K47- and -K118





^ If the ABS warning light -K47-, -2-, goes out, but the warning light for brake system -K118-, -3-, remains on, then the malfunction may be:
-a- The parking brake is applied.
-b- The brake fluid level is too low.
-c- There is a malfunction in the activation of the warning light for brake system -K11 8-.
Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations binder
^ If the ABS warning light -K47- -2- and the warning light for brake system -K1 18- -3- light up, the ABS system is faulty and the EBD (Electronic brake pressure distribution) is not functioning.

WARNING: After the ABS warning light - K47- and warning light for brake system -K118- have lighted up, it is possible that the rear wheels will lock up earlier.





ASR/ESP control lamp -K155
^ If the stabilization program ASR/ESP control lamp -K155--4- does not go out after ignition is switched off and test sequence is completed then the malfunction may be:
-a- Short to positive in ASR/ESP button -E256-.
-b- There is a malfunction in the activation of the stabilization program ASR/ESP control lamp -K155-.
-c- The ASR/ESP has been switched off via button -E256-.
There is a malfunction present which exclusively affects the safety systems of the ASR/ESP. The ABS/EDL and EBD safety systems of the vehicle remain fully functional.
If stabilization program ASR/ESP control lamp -K155- flashes while driving, the ASR or ESP system is regulating the system.