Front Seat Backrest, Removing and Installing

Front Seat Backrest, Removing And Installing

NOTE:
- Removal and installation is described for left side of vehicle. The same instructions apply for removal and installation for the right-hand side.
- Slight changes may have to be made to removal and installation procedures, depending upon equipment installed in vehicle.

Removing
- Remove seat.







- Pull off adjusting knob - 7 -.







- Unclip two cover caps - 8 -, remove two bolts - 9 - and remove adjusting lever - 10 -.
- Remove bolt - 2 - and remove trim - 1 -.
- Remove bolt - 12 -.
- Remove trim - 11 -.
- Unclip left cover cap - 3 - and right cover cap - 6 -.
- Unclip wiring under seat.







- If present, disconnect harness connector - 1 - for backrest heater.
- Pry out retaining clip - 2 - and remove airbag wiring - 3 -.
- Remove fitting bolts - 4 - on both sides of seat and remove backrest.

Installing







- Installation is performed in the reverse order of removal.

NOTE: Fitting bolts - 4 - must be secured with locking compound D 000 600 A2 (tightening torque 20 Nm).