Timing Belt: Testing and Inspection

Semi-automatic toothed belt tensioning roller, checking

Installation position





^ Angled retainer (arrow) must locate in cut-out on cylinder head.

Requirements
^ Engine must only be hand touch warm.

Test sequence
^ Set engine to TDC No. 1 cylinder.





^ Press hard with thumb on toothed belt. Indicator -2- must move.
^ Release thumb pressure on toothed belt and turn crankshaft two turns in engine direction of rotation until engine is again at TDC No. 1 cylinder. When doing this it is essential that last 45° (1/8 turn) is performed without stopping.
Tensioning roller must return to its original position. (Notch -1- and indicator -2- are again aligned).

Note: Use a mirror when checking.