Customer Safety Information

Safety precautions
To prevent injuries to persons and/or damage to the fuel injection and ignition system, the following must be observed:
^ Do not touch or disconnect ignition wiring when the engine is running or being turned at starter speed.
^ The ignition must be switched off before connecting or disconnecting injection or ignition system wiring or tester cables.
^ If the engine is to be turned at starter speed, without starting:





^ Pull 6-pin connector off ignition coil with final output stage (arrow).





^ Remove fuse No. 32 from fuse holder.

Note: Removing fuse 32 interrupts the voltage supply to the injectors.

Observe the following if test and measuring instruments are required during a road test:

^ Test and measuring instruments must be secured to the rear seat and operated by an assistant from this location.
If test and measuring instruments are operated from front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.
^ Erase engine control module DTC memory because disconnecting connectors from injectors will have caused a to be recorded.