Evaporative Emissions System: Service and Repair

Parts of EVAP canister system, removing and installing







1 Bracket
2 8 Nm
3 Washer
4 Mounting screw
5 Leak detection pump (LDP) -V144-*
- Under wheel housing liner in rear left wheelhousing
6 Connector
- black, 3-pin
7 Connection piece
- Check for secure fitting
- To disengage, squeeze together at front
8 Connection hose
- Intake side
- Check for secure fitting
- secure with spring type clamps
9 Connection hose
- Pressure side
- Check for secure fitting
- secure with spring type clamps
10 Connecting piece
11 Air filter for diagnostic pump
12 Connector
- black, 2-pin
13 Vacuum line
- Check for secure fitting
- secure with spring type clamps
- to upper part of intake manifold, item 1
14 Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-*
- Installation position: Arrow points in direction of flow
15 Bracket
- at upper air filter housing, item 14
16 Retaining ring
17 Vent line
- from fork at fuel tank filler tube, item 14
- Check for secure fitting
- secure with spring type clamps
18 Fork
19 Connection tube
20 EVAP canister
- In spare wheel well at vehicle floor
21 15 Nm
22 Vacuum line
- Check for secure fitting
- to upper part of intake manifold, item 5.