Installation Notes

Installation Notes







- Apply adhesive material all around onto pre-coating - 1 - at right angle to window.

CAUTION: Window must be installed within 10 minutes, otherwise bonding properties of window adhesive will be impaired.

- Insert window into window cut out using two Double suction lifters V.A.G 1344, center and press in up to spacer.
- Gap dimension of windshield.
- Rear window gap dimension.
- Gap dimension of rear window, wagon, 4.5 mm all around.
- Secure windshield using Window adjuster 443 845 631 A during curing time.
- Plenum chamber cover must always be installed as described on page.
- Re-affix any stickers (e.g. for airbag).







- When installing mirror - 1 -, attach at 6090° offset to installation position and turn - arrow - until retaining spring engages.
- Install interior mirror.
- Install interior mirror with rain sensor.

- Secure rear window using adhesive tape during curing time.
- If adhesive bead has been applied too thick and adhesive expands onto area of window heating,then excess adhesive must be removed.
- First install side window of wagon using securing pins.
- When re-using removed window.







- Insert window into body flange and align to C-pillar - arrow A - and D-pillar - arrows B -.

- Secure side window using adhesive tape during curing time.