Guide Control Arm Mounting, Replacing

Guide control arm mounting, replacing
Special tools and equipment required





- 3301 Assembly tool
- 3346 Assembly tool
- 3347 Assembly tool

Aluminium guide control arm must be clamped in a vice only with protective clamps!





Pulling hydro-mounting out from guide control arm





Hydro-mounting installation position
- The arrows on hydro-mounting -1- and groove -2- point toward the joint pin.
- The maximum permissible deviation is + 5°-.





Pulling in hydro-mounting
- Insert hydro-mounting -A- in special tool -3347/2-.
- Tension sleeve -3347/1-, spindle -3346/2- and hex nut together.
- Pull in hydro-mounting -A- onto stop.