Glass Panel For Sunroof (Height Adjustment), Adjusting (Meritor)

Glass Panel For Sunroof (height Adjustment), Adjusting

NOTE: Glass panel height adjustment is to be performed after glass panel has been closed out of sliding position.

Zero position of sunroof OK.
- Tilt sunroof open.
- Slide sliding headliner toward rear.

Vehicles up to calender week 35 2002 (CW 35/02)







- Unclip lower trim - 2 - in front area to vehicle center and unhook at rear.
- Unclip upper trim - 1 - at front and in center and remove at rear.

Vehicles from calender week 36 2002 (CW 36/02) on
In vehicles from calender week 36 2002 (CW 36/02) on, a trim piece is installed in place of a lower trim and an upper trim.







- Unhook lower trim - 1 - from lower part of slotted guide rail - 3 -.
- Remove lower trim from securing pins - 4 -.
- Unhook lower trim - 1 - at top, rear - 2 -.
- Remove lower trim - 1 -.

Continued for all vehicles







- Loosen securing bolts - 3 - (Torx T25; 4.5 Nm).
- Drive glass panel into "open" position.
- Drive glass panel into "closed" position.
- Perform glass panel height adjustment at front and rear on both sides as follows:

Panel adjustment at front:







- a - = 0 - 1 mm lower than roof
- arrow - = direction of travel

Panel adjustment at rear:







- b - = 0 - 1 mm higher than roof
- arrow - = direction of travel
- Tighten glass panel bolts (4.5 Nm).

Always adjust left and right-hand glass panel sides symmetrically.

- Tilt sunroof open.

Vehicles up to calender week 35 2002 (CW 35/02)







- Hook upper trim - 1 - at rear and clip on in center and at front.
- Hook in lower trim - 2 - at rear and clip in at front.

Vehicles from calender week 36 2002 (CW 36/02) on

NOTE:
- In vehicles from calender week 36 2002 (CW 36/02) on, a trim piece is installed in place of a lower trim and an upper trim.
- Trim piece and trim must not be replaced against each other. Clearance for mechanical components is otherwise not guaranteed.







- First hook in trim piece - 1 - at top, rear - 2 -.
- Engage trim piece - 1 - with securing pins - - 4 -.
- Engage trim piece - 1 - in lower part of slotted guide rail - 3 -.