Sunroof With Glass Panel (Meritor)

Sunroof With Glass Panel, Assembly Overview







1 Glass panel for sunroof (single pane safety glass)
- Removing glass panel for sunroof
- Installing glass panel for sunroof
- Adjusting glass panel for sunroof
2 Panel seal
- Adjusting panel seal
- Seal join at center in rear area
- Panel seal, replacing
3 Sliding headliner
- Removing and installing sliding headliner
4 Countersunk screws (microencapsulated)
- Always use new countersunk screws
- 3.5 Nm
5 Slider
6 Upper trim
- Up to calender week 35 2002 (CW 35/02)
7 Lower trim
- Up to calender week 35 2002 (CW 35/02)
8 Water channel
- Removed together with slotted guide rail
9 Guide locking hook
10 End piece
- Use Butyl adhesive sealing cord AKL 450 005 05 for sealing
11 Installation unit
- Removing and installing installation unit
- if necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise functions cannot be guaranteed.
12 Bolt
- 3.5 Nm
13 Hex wrench for emergency operation
- Clipped in on drive motor cover
14 Drive motor
- Adjusting drive motor (zero position)
15 Spring
16 Wind deflector
17 Torx screw
- Torx T25
- 4.5 Nm
18 Rear guide
- Removed together with slotted guide rail
19 slotted guide rail
20 Gap bracket
- Removed together with slotted guide rail
21 Trim piece
- From calender week 36 2002 (CW 36/02) on

NOTE: Trim piece and trim must not be replaced against each other. Clearance for mechanical components is otherwise not guaranteed.