Tightening Sequence For Compact Bracket to Cylinder Block

Tightening sequence for compact bracket to cylinder block
Work sequence
- Position compact bracket on cylinder block (observe dowel sleeve between compact bracket and cylinder block).
- Tighten compact bracket as shown in following tightening sequence:

1. Tighten bolt - A 45 Nm
2. Tighten bolt - B 45 Nm
3. Tighten bolt - C 45 Nm
4. Tighten bolt - D 45 Nm
5. Tighten bolt - E 45 Nm
6. Tighten bolt - F 45 Nm





Part III
1. 45 Nm
2. Trim
3. Cylinder block
4. 10 Nm
5. Bracket
^ For vacuum reservoir
6. Vacuum reservoir
7. 15 Nm
8. Seal
^ Replace
9. Oil filter bracket
10. 15 Nm + 1/4 turn (90°) further
^ Replace
^ First install upper left and lower right bolts, then tighten four bolts diagonally and alternately
11. Engine speed (RPM) sensor -G28-
12. Union
^ For thermostat
13. 15 Nm
14. O-ring
^ Replace
15. Thermostat
^ Checking- heat-up thermostat in water
^ Opening begins- approximately 85°C
^ Opening ends- approximately 105°C
^ Opening lift- min. 7mm
16. 45 Nm
17. Compact bracket
^ For Generator, power steering pump and air conditioning compressor
18. Oil sump
^ Clean sealing surface before installing
19. 15 Nm