Jetta Wagon

Rear Lid (Jetta Wagon), Assembly Overview







1 - Rear lid
- Gap dimension Body panel gaps; Body, rear

2 - Trim
3 - Rubber stop
4 - Gas-filled strut
- Venting gas

5 - Ball stud
- 10 Nm

6 - Bolt
- 22 Nm

7 - Closure plate
- Adjusting - within elongated holes
- Gap dimension Body panel gaps; Body, rear

8 - Cap
9 - Pop rivet
10 - Hex nuts
- 22 Nm

11 - Hinge
12 - Bolt
- 10 Nm

13 - Identification plate
- Press on only on hatched area
- Replacement part has two foils. First foil covers adhesive surface, second must be removed after installing.

14 - Internally threaded pop rivet
- Tighten using Pop rivet tongs V.A.G 1765A