Sealing Flanges and Drive Plate Removing and Installing

Sealing flanges and drive plate, removing and installing

Note: For repairs to the clutch.





1-9O Nm + 1/4 turn (90°) further
^ Always replace
^ Counterhold with 3415 to loosen and tighten
^ Threads and shoulder must be free of oil and grease
2-Crankshaft toothed belt sprocketCylinder Block Assembly
3-15 Nm
4-Oil seal
^ Replacing.
5-Sealing flange
^ Must be located on dowel sleeves
^ Clean sealing surface before installing
^ Insert with silicone sealant D 176 404 A2
^ Removing and installing.
^ To remove and install remove oil pan
6-Cylinder block
^ Removing and installing crankshaft.
^ Disassembling and assembling pistons and connecting rods.Cylinder Block Assembly
7-60 Nm + 1/4 turn (90°) further
^ Always replace
8-Flywheel/drive-plate
^ To remove and install flywheel counterhold with 3067
^ Removing and installing drive plate.
9-Intermediate plate
^ Must be located on dowel sleeves
^ Do not damage/bend when assembling
10-Sealing flange with oil seal
^ Only replace complete
^ To remove and install, remove oil pan.
^ Before installing, remove oil residue from crankshaft journal using a clean cloth
^ Do not additionally oil or grease the oil seal sealing lip
^ Use protective sleeve supplied when installing
^ Remove protective sleeve first after sealing flange has been slid onto crankshaft journal