Sealing Flanges & Flywheel/Drive Plate, Removing and Installing
Sealing flanges and flywheel/drive plate, removing and installing
Note: Servicing the clutch.
Refer to Transmission and Drivetrain
1. Seal
^ Do not additionally oil or grease oil seal sealing lip
^ Before installing, remove oil residue from crankshaft journal using a clean cloth.
^ Replacing crankshaft oil seal belt pulley end
2. Sealing flange
3. Cylinder block
^ Removing and installing crankshaft
4. Flywheel/drive plate
^ To remove and install flywheel counterhold with 3067
5. 60 Nm + 1/4 turn (90°) further
^ Replace
6. Intermediate plate
^ Must be located on dowel sleeves
^ Do not damage/bend when assembling
7. 15 Nm
8. Sealing flange with oil seal
^ Replace complete only
^ Do not additionally oil or grease oil seal sealing lip
^ Before installing, remove oil residue from crankshaft journal using a clean cloth
^ Use protective sleeve supplied when installing
^ Remove protective sleeve first after sliding sealing flange onto crankshaft journal