Ignition Components, Removing and Installing - II

Ignition Components, Removing And Installing (vehicles With Engine Code BBW)







NOTE: Engine Control Module (ECM) with harness connectors.

1. Ignition wire
- 4 to 8 kilo Ohms
- With interference suppression connector and spark plug connector
2. Ignition coil with power output stage (-N70-, -N127-, -N291-, -N292-)*
- Ignition wires connection:A = Cylinder 1; B = Cylinder 2; C = Cylinder 3; D = Cylinder 4
3. 10 Nm
4. Connector
- 6-pin
5. Knock Sensor (KS) 1 -G61-*
- Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
- Terminals of sensor and connector are gold-plated
6. Connector
- 2-pin
- For Knock Sensor (KS) 1 -G61-
- Before disconnecting, mark allocation of connector to component
- Terminals of sensor and connector are gold-plated.
7. Knock Sensor (KS) 2 -G66-*
- Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
- Terminals of sensor and connector are gold-plated
8. Connector
- 2-pin
- For Knock Sensor (KS) 2 -G66-
- Before disconnecting, mark allocation of connector to component
- Terminals of sensor and connector are gold-plated
9. 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
10. Spark plug,25 Nm
- Type and spark plug gap, Spark plugs, test data
11. Camshaft
12. 9 Nm
13. Camshaft Position (CMP) sensor -G40-*
- Terminals of sensor and connector are gold-plated
14. O-ring
- Always replace
15. Connector
- Black, 3-pin
- For Camshaft Position (CMP) sensor -G40-
- Terminals of sensor and connector are gold-plated