Part II
Part II
NOTE: Components marked with an * are checked by the On Board Diagnostic (OBD).
Components marked with ** are checked by the Output Diagnostic Test Mode (DTM).
Vehicles with engine code AWP, AWV
1. Pressure regulator valve
For crankcase ventilation
2. To crankcase breather valve
3. Charge pressure bypass valve
Checking refer to Testing and Inspection - Procedures Testing and Inspection
4. Connecting pipe/hose
To Recirculating valve for turbocharger -N249- */**
5. Connecting pipe/hose
From charge pressure bypass valve to upper air guide duct
6. From air filter
7. upper air guiding duct
Observe installed position of heat protection mat
Vehicles with engine code AWP, AWV with quick-release connection (with O-ring and securing brace)
8. Bracket
9. 40 Nm
10. 25 Nm
11. For connecting hose of connecting piece/charge air cooler at bottom
12. O-ring
Replace
13. Circlip
Replace
14. 10 Nm
15. From turbocharger exhaust connection
16. Connecting pipe/hose
17. Connecting pipe/hose
To vacuum diaphragm for Wastegate bypass regulator valve -N75-
18. Circlip
Check seated securely
19. O-ring
Replace
20. Intake hose
To intake connection of exhaust turbocharger
21. Connecting pipe/hose
To vacuum booster
22. Wastegate Bypass Regulator Valve -N75- */**
The valve will be activated by the Engine Control Module (pulsed)
Check activation with Output Diagnostic Test Mode (DTM)