Parts of the Ignition, Removing and installing

Parts Of The Ignition, Removing And Installing (Vehicles With Engine Code AWP, AWV)







1 Connector
- Black, 4-pin
2 Ignition Coil 1 with Power Output Stage - N70-, Ignition Coil 2 with Power Output Stage -N127-, Ignition Coil 3 with Power Output Stage -N291-, Ignition Coil 4 with Power Output Stage -N292-
3 Snap ring
- for Ignition Coil 1 with Power Output Stage -N70-, Ignition Coil 2 with Power Output Stage -N127-, Ignition Coil 3 with Power Output Stage -N291-, Ignition Coil 4 with Power Output Stage -N292-
- Replace if damaged
4 Spark plug, 30 Nm
- remove and install with 3122 B
- Type and spark plug gap, test data, spark plugs
5 Connector
- black, 3-pin
- Terminals of sensor and connector are gold-plated
6 10 Nm
7 Camshaft Position (CMP) Sensor -G40-*
8 25 Nm
9 Washer
- Conical
10 Face plate
- For Camshaft Position (CMP) Sensor -G40-
- note position when installing
11 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
12 Knock Sensor (KS) 1 -G61-*
- Terminals of sensor and connector are gold-plated
- Component location: Cylinder block, intake side
13 Knock Sensor (KS) 2 -G66-*
- Terminals of sensor and connector are gold-plated
- Component location: Cylinder block, intake side
14 Connector
- 2-pin
- Terminals are gold-plated
- Black for Knock Sensor (KS) 1 -G61-
- Black for Knock Sensor (KS) 2 -G66-
- Mark connector before removing
15 Ground (GND) wire
- Do not loosen or tighten unless ignition is switched off.
16 10 Nm
- Do not loosen or tighten unless ignition is switched off.