Connector Locations

Instrument cluster multi-pin connector assignments


NOTE:
- Instrument cluster must not be disassembled.
- Troubleshooting specific systems and circuits
- Additional information







Multi-pin connectors on instrument cluster

32-pin connector -1-, blue
- Basic functions
- Connector assignments

32-pin connector -2-, green
- Expanded functions
- Connector assignments







32-pin multi-connector, blue

1 - Terminal 15 - positive (ignition on)
2 - Indicator lamp for turn signal, right
3 - Output signal 1 from electronic speedometer
4 - Open
5 - Fuel gauge
6 - Airbag Malfunction Indicator Lamp (MIL)
7 - Terminal 31 - sensor/sender Ground (GND)
8 - Engine Coolant Temperature (ECT) gauge
9 - Terminal 31 - Ground (GND)
10 - Oil pressure warning lamp
11 - Open
12 - Terminal 61 - warning lamp for Generator (GEN),
13 - 16 - Open
16 - Warning lamp for rear hatch/trunk lid open







17 - Terminal 56a - indicator lamp for high beam headlight
18 - Indicator lamp for turn signal, left
19 - Open
20 - Terminal 58b - instrument cluster illumination
21 - Driver's door open warning buzzer
22 - Warning lamp for low Engine Coolant Level (ECL)
23 - Terminal 30 - positive (B+)
24 - Terminal 31 - Ground (GND)
25 - Data Link Connector (DLC) K-wire
26 - Parking lights, right (signal for "lights on" warning buzzer)
27 - Parking lights, left, (signal for "lights on" warning buzzer)
28 - Input signal - Speedometer Vehicle Speed Sensor (VSS)
29 - Brake fluid level warning lamp
30 - Terminal 86s - Ignition key warning buzzer
31 - Seat belt warning lamp/buzzer
32 - Open







32 - pin connector, green

1 - Open
2 - Reading coil for immobilizer
3 - Open
4 - Open
5 - W-wire
6 - Rear spoiler
7 - Brake pad wear indicator
8 - Open
9 - Open
10 - Low fuel level warning
11 - Signal for vehicle stationary
12 - Open
13 - Warning lamp for dual circuit brake system and handbrake
14 - 16-Open
15 - Open
16 - Open
17 - Reading coil for immobilizer







18 - Open
19 - Interface - CAN Data Hi-Bus
20 - Interface - CAN Data Lo-Bus
21 - 26-Open
27 - Interface - On Board Diagnostic (OBD) CAN Data Hi-Bus
28 - Interface - On Board Diagnostic (OBD) CAN Data Lo-Bus
29 - Open
30 - Output signal 2 from electronic speedometer (where applicable)
31 - Selector lever display (automatic transmission)
32 - Open