Internal Oil Line, Removing and Installing

Internal oil line, removing and installing, 01V, 5 SPD. A/T (FWD)

Special tools and equipment

3381 Fitting tool:

Faulty O-rings on the internal oil line allow ATF to enter the differential. This then becomes overfilled and oil will seep out of the breather holes of the differential.

If an oil line is removed, it should generally be replaced.

The oil line should only be inserted using fitting tool 3381. Otherwise there is a danger of the oil line becoming bent, which will cause leaks to occur.

Removing
- Remove valve body.





- Pry internal oil line off transmission housing using a screwdriver.

Installing
- Replace O-rings.
- Insert internal oil line into fitting tool 3381.

Open side of fitting tool 3381 faces toward outside of transmission.





- Using a plastic hammer, knock the oil line into the transmission housing until the tool makes contact.

Ensure that the oil line is kept straight; knock both ends in evenly.

- Install valve body.
- Fill with ATF; check ATF level and top off.