Toe Constant "S", Adjusting

Toe constant "S", adjusting





^ Loosen nut - A -.
^ Unscrew bolt - B - approximately 4 mm.
^ Push toe rod joint downward onto stop.
^ Screw in adjustment bolt - B - until the exact specification is achieved.
^ Tighten hex nut - A - and check value.

Always use new hex nuts!





If the range of adjustment is not sufficient for adjusting toe-in curve, the wire ring - arrow - can be removed.





^ Tighten bolt - B -.
^ Lower vehicle to initial position again.
^ Screw threaded spindle down.

Does not apply for vehicles with sports suspension!
^ Bounce suspension of vehicles with standard suspension several times.

Checking toe constant after adjusting

The alignment unit checks toe constant again.

If the measured values for the second check are within the check value tolerances then the adjustment is OK.

If the measured values lie outside the check values, then the adjustment must be repeated in the raised position again.