Ignition Coil: Service and Repair

Parts of ignition, removing and installing


NOTE:
- Cylinder bank 1 is located on right side in direction of travel.
- Cylinder bank 2 is located on left side in direction of travel.
- Engine Control Module (ECM) with harness connectors, item 6 .







1 Spark plug, 30 Nm
- Type and spark plug gap, test data, spark plugs
2 Spark plug connectors with ignition wires
- Check, ignition coil
3 Spacer sleeve
4 Rubber grommet
5 10 Nm
6 Ignition Coil-N152-
- with power output stage
- with marking for ignition wires, do not interchange
7 Connector
- black, 5-pin
8 3-pin harness connector
- Terminals are gold-plated
9 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
10 Knock Sensor (KS) 2 -G66-*
- Cylinder bank 2
- Terminals of sensor and connector are gold-plated
11 Knock Sensor (KS) 1 -G61-*
- Cylinder bank 1
- Terminals of sensor and connector are gold-plated
12 10 Nm
13 Camshaft Position (CMP) Sensor 2 -G163-*
- Cylinder bank 2
14 25 Nm
15 Washer
- Conical
16 Face plate
- for Camshaft Position (CMP) sensor
- note position when installing
17 Connector
- Black, 3-pin
- For Camshaft Position (CMP) Sensor -G40- or Camshaft Position (CMP) Sensor 2-G163-
18 Camshaft Position (CMP) Sensor -G40-*
- Cylinder bank 1.