Speed Signal, Checking
Speed Signal, Checking
Recommended special tools and equipment
- V.A.G 1526 multimeter or V.A.G 1715 multimeter
- V.A.G 1594 connector test kit
- Wiring diagram
Test requirements
- The respective fuses of Motronic Engine Control Module (ECM) -J220- must be OK
- Battery voltage must be at least 11.5 volts.
- Speedometer -G21- must be OK.
Test sequence
NOTE: To test speed signal, vehicle must be driven. This requires a second person.
WARNING: Secure Scan Tool (ST) on the rear seat and have it operated from there by second technician.
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Start engine and let run at idle.
- Under address word 33, select "Diagnostic mode 1: Check measured values."
- Select the measuring value "PID 13: Vehicle speed".
- Perform a road test, and have the 2nd person observe the indication on the display.
- Check specified value of the vehicle speed:
- End diagnosis and switch ignition off.
If no speed is indicated:
- Connect test box to control module wiring harness. connect test box for wiring test. Test Box, Connecting For Wiring Test
Vehicles with engine code AHA
- Connect multimeter between sockets 2+20 (speed signal) of test box for voltage measurement.
Vehicles with engine code ATQ
- To measure voltage, connect multimeter between sockets 3 (terminal 15) +54 (speed signal) of test box.
Continuation for all vehicles
- Jack up front left wheel.
- Switch ignition on.
- Rotate front wheel, and observe voltage indicated while doing so.
Specified value: 0.0 to at least 4.0 V, fluctuating
NOTE: The right front wheel must not turn during this, hold it steady if necessary.
If indicated voltage does not oscillate:
- Remove instrument cluster:
- Check wire connection from Engine Control Module (ECM) to Speedometer -G21- according to wiring diagram.
- Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes