Differential, Removing and Installing

Differential, removing and installing, 01A, 5 SPD. M/T (AWD)

Note:
^ General repair notes.
^ Adjustments are required when replacing components marked with 1).





1. Air vent sleeve
^ With rubber valve
^ Installation position

2. Final drive housing 1)
3. Large tapered roller bearing outer race 1)
4. Shim "S1"
^ Note thickness

5. Cover for final drive 1)
^ With O-ring
^ Replacing
^ Insert O-ring with oil

6. Torx bolt, 25 Nm
7. Oil seal
^ Replace

8. Socket head bolt, 25 Nm
9. Right drive flange

10. Oil filler plug, 35 Nm
^ Checking gear oil level in rear final drive

11. Differential with ring gear 1)

12. Oil drain plug, 35 Nm
13. Socket
^ Holds magnet in position
^ Press in until stop

14. Magnet
15. Small tapered roller bearing outer race 1)
16. Shim "S2"
^ Note thickness

17. Oil seal
^ Replace

18. Left drive flange
19. Socket head bolt, 25 Nm
20. Cover





Drive flange, removing and installing





Press in cover up to stop





Installation position of vent sleeve

The vent sleeve must protrude 13 mm measurement - a - out of housing after pressing in.

The slot in rubber valve is parallel to direction of travel.