Front Axle Camber, Centering

Front axle camber, centering
Only by moving the subframe is it possible to change the camber slightly.

Note: In some cases it may be necessary to elevate the engine with an engine support to relieve some tension and weight from the sub frame in order to move it.

^ Remove noise insulation tray.





^ Loosen hex bolts - 1 -, - 2 -, - 5 -, - 6 -, - 7 - and - 8 -.





^ Move subframe with a plastic coated pry bar until the specified value for camber is achieved.

CAUTION: Do not damage components or their surface protection.





^ Screw in new hex bolts - 7 - and - 8 -.
^ Screw in new front hex bolts - 5 - and - 6 - and tighten
^ Tighten new hex bolts - 1 -, - 2 -, - 3 - and - 4 -.
^ Install sound insulation below engine/transmission.

CAUTION: The toe must be checked after each camber adjustment.