Front Axle to Unladen Position, Lifting

Special tools, testers and auxiliary items required
- Engine and transmission jack VAG 1383 A
- Tightening strap T10038
- Support T10149

Note:
- All chassis component bolts with bonded rubber bushings must be tightened with the suspension in the curb weight position (unladen).
Bonded rubber bushings have a limited turning range.

Before components with bonded rubber bushings are tightened, they have to be brought to a position which matches the position when the vehicle is being operated (curb weight position).

Otherwise, bonded rubber bushing will be distorted, resulting in reduced service life.

This position can be simulated on the lift by lifting the axle on one side using engine and transmission jack V.A.G 1383 A and the support T1 0149.





- Measure dimension - a - with a tape measure from the center of the wheel to the lower edge of the wheelhousing.

The measurement must be taken in curb weight position (unladen).

- Write down the measurement. It will be needed for tightening the nutslbolts.

Before the individual suspension is raised on one side, the vehicle must be secured to the lifting arms on the hoist using the straps T1 0038.

Caution!

If the vehicle is not secured, there is a risk that it may slip off the hoist.

- Turn wheel hub until one of the holes for the wheel bolts is at the 12 o'clock position.

- Install wheel hub support T10149 with a wheel bolt to wheel hub.

The nutslbolts can only be tightened if dimension - a - is the same as the measurement taken between the center of the wheel hub and the lower edge of the wheelhouse before work started.





- Raise steering knuckle using engine and transmission jack V.A.G 1383 A until dimension - a - is reached.

Caution!

^ Do not raise or lower vehicle while engine and transmission jack is under vehicle.

^ Do not leave engine and transmission lift V.A.G 1383 A under the vehicle any longer than necessary.


- Tighten respective nuts/bolts.

- Lower wheel bearing housing.

- Remove engine and transmission jack V.A.G 1383 A from under the vehicle.

- Remove wheel hub support T1 0149.