01V, 5 SPD. A/T (FWD)

Gear oil in front final drive, checking, 01V, 5 SPD. A/T (FWD)

Special tools and equipment required

VAG 1306 Drip tray:

3247 Socket AF 8:

Oil level is checked with transmission installed
- Drive the vehicle a short distance to warm up the gear oil.
- Position vehicle on hard, level standing e.g. on 4 pillar hoist or over pit.
- Switch off engine and let gear oil drain for 5 minutes.
- Place drip tray VAG 1306 underneath.





- Remove sealing plug -arrow-.

The oil level is correct when the front final drive is full to the lower edge of the filler hole.

- Allow excess gear oil to pour out or top up as necessary.
- If gear oil needs to be replenished following repair work, fill front final drive slowly and evenly over a period of at least 5 minutes until the gear oil drips out over the lower edge of the oil filler hole.

A filling time of at least 5 minutes is necessary to allow the oil to settle evenly in the differential and cavity.





- Screw in original sealing plug -arrow-.
- Drive the vehicle a short distance to warm up the gear oil.
- Check oil level in front final drive.
- If the oil level is OK, replace front final drive sealing plug -arrow-.