Input Shaft Ball Bearing and Multi-Function Sensor, Removing and Installing

Input shaft ball bearing and multi-function sensor, removing and installing, 012/01W, 5 SPD. M/T





1. Transmission housing
^ With differential and drive flanges
^ Breather installation position
^ Breather made out of different materials for aluminum or magnesium transmissions

2. Inner Torx bolt
^ Self-locking
^ Always replace
^ Black; for transmissions made out of aluminum only
^ Bright; for transmissions made out of aluminum or magnesium
^ For aluminum transmissions
^ 35 Nm
^ For magnesium transmissions
^ 25 Nm

3. Guide sleeve
^ Installed with O-ring and seal for input shaft
^ Guide sleeve made of different materials for aluminum or magnesium transmissions
^ Installed position: oil drain hole points downward

4. Dished washer
^ Small diameter facing guide sleeve (convex side)

5. Circlip
6. Ball bearing
7. Circlip
8. Input shaft
9. Bolt
^ Black; for transmissions made out of aluminum only
^ Bright; for transmissions made out of aluminum or magnesium
^ For aluminum transmissions
^ 25 Nm
^ For magnesium transmissions
^ 15 Nm

10. Locking plate
^ For multi-function sensor
^ Locking plate made out of different materials for aluminum or magnesium transmissions
^ Allocate via Electronic Parts Catalog (ETKA)

11. Multi-function sensor
12. Connector for multi-function sensor
13. Bolt, 10 Nm
14. Cover for shift rod
15. Gear lock





Breather installation position

The breather must protrude 21 mm out of housing after pressing in.