Footwell Lamps

Footwell Lamps

CAUTION!
When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool (plastic wedge, screwdriver) will be positioned using commercially available adhesive tape.

Footwell lamps:

• Left Front Footwell Illumination (L151)

• Right Front Footwell Illumination (L152)

• Left Rear Footwell Illumination (L106)

• Right Rear Footwell Illumination (L107)

• The front foot well lamps are located in trim beneath instrument cluster.

• The rear foot well lamps are installed at rear in center of front seats.

• Only glass socket lamps 12 V, 3 W must be installed, even when glass socket lamps 12V, 5 W were previously installed.

• Removal and installation for all foot well lamps is performed in the same way and is only described for one lamp.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Carefully pry out foot well lamps using a screwdriver.





- Release the connector and disconnect it.

Bulb, replacing

- Disengage retaining tabs - 1 - and remove heat shield - 2 - from diffusion lens of foot well lamp.





- Carefully pry bulb from socket.





• Only glass socket lamps 12 V, 3 W must be installed, even when glass socket lamps 12V, 5 W were previously installed.

- Replace bulb (12V, 3 W).

Installing

Install in reverse order of removal.