Access/Start Authorization Control Module

Access/Start Authorization


Access/Start Authorization Control Module

Removing

CAUTION!
When disconnecting battery, procedure must always be followed as described in the repair information --> [ Battery, with Auxiliary Battery or Two-Battery Layout, Disconnecting and Connecting ] Battery, with Auxiliary Battery or Two-Battery Layout, Disconnecting and Connecting. Not adhering to sequence will result in the deactivation of Main Battery Switch -E74- and subsequent damage to electrical system components.

- Disconnect battery --> [ Battery, One-Battery Layout, Disconnecting and Connecting ] Battery, One-Battery Layout, Disconnecting and Connecting.

- Remove lower storage compartment on driver side.

- Push locking hooks of bracket outward - arrows B - and pull Access/Start Authorization Control Module (J518) - 1 - behind bracket forward - arrow A -.





- Release - arrow A - locking mechanism - 1 - of multi-pin harness connector - 2 -.





- Disconnect - arrow B - multi-pin harness connector - 2 - from Access/Start Authorization Control Module (J518).

- Disengage multi-pin harness connector - 3 - and disconnect it from Access/Start Authorization Control Module (J518) - arrow C -.

- Remove Access/Start Authorization Control Module (J518) from bracket.

Installing

Install in reverse order of removal, noting the following:

- The strap - 1 - for Access/Start Authorization Control Module (J518) must first be inserted into guide at top.

- Next, strap - 2 - is clipped into bracket.





• If Access/Start Authorization Control Module (J518) is replaced, work sequence --> [ Access/Start Authorization Control Module, Coding ] Access/Start Authorization must be performed.