Toothed Drive Belt Assembly Overview

Toothed Drive Belt Assembly Overview





1 Toothed belt cover, upper

2 100 Nm

3 25 Nm

4 Camshaft sprocket

5 Hub

• With sensor wheel

• Use counter-holder (T10051) to loosen and tighten

• To remove, use pulling fixture (T10052)

• Removing and installing => [ Camshaft ] Service and Repair.

6 10 Nm

• Replace

7 Stud bolt

• 15 Nm

8 Toothed belt cover, rear

9 25 Nm

10 Grommet

• Replace if damaged

11 20 Nm + 45° (1/8 turn) additional turn

12 Tensioner

13 20 Nm

14 Idler

15 Coolant pump

• Removing and installing => [ Coolant Pump ] Service and Repair.

16 Crankshaft sprocket

17 120 Nm + 90° (1/4 turn) additional turn

• Replace

• Use counter-holder (3099) to loosen and tighten

• Do not additionally oil or grease threads or collar

• Additional rotation can occur in several stages

18 15 Nm

19 Toothed belt cover, lower

20 Vibration damper

• Only possible to install in one position - Bores are offset

21 10 Nm + 90° (1/4 turn) additional turn

22 Cover

23 Toothed belt

• Mark direction of rotation before removing

• Check for wear

• Do not kink

• Removing and installing, tensioning => [ Toothed Belt ] Toothed Belt.

24 40 Nm + 180° (1/2 turn) additional turn

• Replace

25 Toothed belt cover, center

26 Engine mount bracket

• Multiple versions

• Removing and installing => [ Engine Mount Bracket ] Service and Repair.