Halogen Headlamps, Installation Position, through MY 09

Halogen Headlamps, Installation Position, through MY 09

• It is not necessary to remove the front bumper to aim the headlamps.

• Illustrations depict left headlamp.

When checking installation position of headlamp, determine that headlamp has no uneven gap dimensions to body, otherwise installation position must be corrected.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Procedure

- Remove the radiator grille.

- Loosen the screw - arrow - on the top of the headlamp.






- Loosen the screw - arrow - on the bottom of the headlamp on the left side.






- Loosen the screw - arrow - on the bottom of the headlamp on the right side.






- Turn the adjusting bushing - arrow - on the front of the headlamp to adjust the headlamp so that it is flush with the vehicle body.






- Tighten the threaded connections to the tightening specification. Refer to => [ Halogen Headlamps Overview, through MY 09 ] Halogen Headlamps Overview, through MY 09.

- Check and correct the headlamp position and make sure the gap dimensions are even.

- Install the radiator grille.

- Check headlamp for functions.

- Check and adjust the headlamp adjustment.